BD-2003E Electric Core Saw 230V/50 hz

THIS ITEM HAS BEEN DISCONTINUED.
CALL 1-888-747-8593 FOR NEXT SUITABLE ALTERNATE SAW

These precision built saws are designed for rapid and accurate sawing of exploratory core specimens. The specialty designed 14" segmented diamond blade allows cutting of hard or dense rock samples and engineered materials. The integral core holder provides for rapid and safe cutting of cylindrical core samples. Adjustable height cutting head accommodates specimen sizes between 1" and 5" in diameter.

BD-2000 Series Features:

• Stay level blade guard gives 180º coverage at all times
• Blade shaft is built with sealed, permanently lubricated, heavy-duty bearings
• Cast-aluminum structural components & jig-welded steel frame assembly
• Convenient ON/OFF switch for operator safety
• Recoil spring return cutting head
• Cast aluminum blade guard with stainless steel water tubes that will not bend or rust
• Adjustable water supply for maximum blade protection
• Thermally protected 3 hp Baldor motor on electric saw
• Submersible electric water pump
• Made in the USA
• 208-240V/50 Hz motor available on request
• One-year limited warranty

• MK-2003E 220V/50Hz 1 Phase

• Core Holder

• BD-62Q Wet Cutting Blade for Quartz, Volcanic Rock & Marble

• BD-62P Wet Cutting Blade for Porphyry Granite

Warning: This equipment contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. These chemicals are contained in various components. fluids and paint including but not limited to fuel, oil, electric motors and batteries. In addition, gasoline/diesel powered equipment emits engine exhaust and fumes, and when serviced, cleaned or maintained generate used oil, waste fluids, fumes, grease, grime and particulates from the component wear and silica dust which contain chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov