HP-30 Slab Saw 220V/60Hz 24" to 30" Slab Saw
Part# 168084
- 2 Hp continuous duty commercial grade motor with thermal overload protection and manual reset
- Fully sealed drive shaft bearing housing
- Rolling element linear bearings in carriage for ease of movement over main guide rails
- Screw drive vise carriage with automatic shutoff
- Silicon bronze clutch block carriage feed engagement system
- Continuously variable vise feed rate, 0-0.5 in./min.
- Chrome plated cast iron parts allow use of waterbased coolants
- Powder coated reservoir and zinc plated hood
- Reservoir bottom drain for ease of sludge removal
- Heavy duty casters with locking wheel brakes
- Large capacity oil/sludge reservoir
- Submersible pump system provides lubrication, flushing and cooling
ADJUSTABLE - 18" VISE OPENING
![]()
HP-30 VISE CARRIAGE
![]()
VISE & CARRIAGE SPEED ADJUSTMENT
![]()
MOTOR AND DRIVE BELT PULLY
![]()
1-1/2 HP CONTINOUS DUTY MOTOR WITH THERMAL OVERLOAD PROTECTION AND MANUAL RESET
![]()
SUBMERSIBLE ELECTRIC PUMP FOR LUBRICATION, FLUSHING AND COOLING
![]()
DIRECT FLUID INJECTION TO ASSIST IN COOLING/FLUSHING BLADE
![]()
Part # | 168084 |
Motor | 2 hp |
Voltage | 220V/60Hz |
Amperage | 8 |
Motor RPM | 1725 |
Blade RPM | 380 |
Arbor | 1" |
Blade Capacity | 30" |
Depth of Cut* | 12.5" |
Vise Opening | 18" |
Coolant Required | 25 Gallons |
Blade Lubrication | Submersible pump |
L x W x H | 67” x 37” x 49” |
Weight | 875 lbs. |
Blade not included with saw. |
Click here to order the 30" MK-303 Lapidary blade*Maximum depth of cut will vary depending on size and shape of specimen.Warranty Period: 1 year from date of purchase against all manufacturing or material defects.
Manufacturing period 6 weeks from date of order.
220 volt 50 or 60 Hz motors are available by special order.
![]()
Warning: This product can expose you to chemicals including nickel and crystalline silica, which are known to the State of California to cause cancer. For more information go to www.P65Warnings.ca.gov
